External elements of the car body Audi 100 C4, petrol

Front bumpers
Removal Remove the lower engine compartment protection. Disconnect and remove the small insert elements of the radiator grille, starting from the right, at the...

Collision damage
The plastic bumpers of the Audi-100 return to their original shape almost unchanged even after severe collisions. Therefore, damage from an accident to parts...

Front of the car
Removal the lower engine compartment protection The lower engine compartment protective paneling contributes to the good aerodynamic coefficient of the Audi...

Hood — removal and installation
Removal Disconnect the engine compartment lighting wires, windshield washer nozzle heating wires, where present, and also the flexible jumper. Advice: if the...

Wings and wheel arch trim
Removal the front wheel arch trim To protect against stone impacts and dirt, the wheel arches are equipped with plastic trim. Remove the corresponding front...

Moldings
Removal moldings Front Fender Molding: Remove Wheel Arch Trim (three screw connections). Unscrew the hex nut from the inside of the wing. Slide the molding...

Doors
The Audi-100 is distinguished by its doors, which consist of two parts. The inner part of the doors, the frame for hanging the mechanisms, is fixed to the...

Dismantling doors
Removal the door trim We will describe the removal of the front door trim. Removing the rear door trim is done in exactly the same way. Removing the window...

External rear view mirrors
Removal For vehicles manufactured before 2/92: Pull the mirror housing back. Loosen the Allen bolt between the mirror housing and the base. For cars...

Front and rear glass
The windshield, rear window and small triangular window in the rear doors are glued in with a "force lock". Thus, they are a structural element in the...

Trunk lid on a sedan
Removal Open the lid. Fold back the luggage compartment trim. Disconnect the plug connection of the wires and pull out the wires. If the vehicle is equipped...

Rear door of the station wagon
Removal Preliminary work: open the back door and prop it up. On both sides at the top, unfasten the corrugated tubes for the wires at the rear door. Remove the...

Rear bumper
Removal Sedan version: fold back the luggage compartment mat. Station wagon version: unlock the middle shelf of the luggage compartment and assemble it....

Sliding sunroof
To ensure proper operation of the hatch, precise installation is required, but providing all the necessary descriptions for this is beyond the scope of this...

Cleaning the water drainage holes
TO #26 No weld is so tight that water cannot penetrate. For this reason, all hollow sections in a car have holes built in to drain water. If they become...

Control of anti-corrosion protection of the underbody
TO #25 The protective layer on the underbody of the car should be carefully checked and renewed if necessary. You can do this yourself if you have the ability...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

100(C4, 1990-1994)

100(C4, 1990-1994, petrol)

100(C3, 1982-1990)

100(C3, 1982-1990, petrol)

100(C3, 1982-1990, diesel)