Heater — design description Heater: 1 - heat exchanger; 2 - fan; 3 - fan motor; 4 - casings of the heater; 5 - guide casing; 6 - bracket for control levers; 7 - draft air damper; 8 -...
Removal and installation of the heater fan Withdrawal Disconnect the wire from the negative battery terminal. Remove the wiper arms. Remove the protective cover. Remove the ventilation duct. Disconnect...
Removal and installation of a heater Disconnect the wire from the negative battery terminal. Disconnect the control unit. Disconnect glass heating hoses. Remove the wiper arms. Remove the...
Removal and installation of facing of a radiator Remove the central fastener and remove the lining from the upper clips. Radiator cover. The arrow shows the latches Installation is carried out in the reverse...
Removal and installation of a forward bumper Withdrawal Unscrew the central mounting bolts and remove the bumper from the side rails. Front bumper mounting brackets: And - bolts of fastening of a bumper...
Front armature — removal and installation Withdrawal Disconnect the wires from the battery terminals. Remove radiator cover. Remove bumper. Unscrew the bumper bracket, being careful not to damage the...
Removal and installation of a cowl Open the hood. Unscrew the bolts securing the hinges to the hood and the bolts securing the air shock absorber. Hood hinges Remove the hood. The hood is...
Removal and installation of front fenders Withdrawal Loosen the spoiler. Remove the plastic fender. Remove headlight and bumper (see above). Remove turn signal. Remove the two lower front mounting...
Rims and decorative caps Rims and decorative caps: 1 - steel rim 431 601 025 A; 2 - decorative cap 443 601 147 A; 3 - aluminum rim 853 601 025; 4 - decorative cap 443 601 165 A; 5...
Front and rear bumper parts Bumper details: 1 - front bumper 443 807 101 C; 2 - central decorative overlay 443 807 243 C; 3, 4 - side molding left 443 807 259 C (right 443 807 260); 5 -...
Interior rear view mirror The interior rear view mirror is glued directly to the windshield using a special adhesive (e.g. Loctite), or an adhesive tablet. Gluing the rearview mirror...
Removal and installation of the ceiling Note. The ceiling is glued directly to the metal of the roof of the car and, if removed, must be replaced with a new one. Withdrawal Remove sun shields. Remove...
Removal and installation of a back bumper Unscrew the bumper fasteners located in the luggage compartment. Remove the bumper assembly from the side rails. Installing the bumper is done in reverse order.