Ignition system — general description Audi 100 cars use two types of ignition systems: a non-contact transistor system on cars without turbocharging and an electronic system on cars with...
Disassembly and assembly of the ignition distributor Order of execution 1. Remove distributor (cm. subsection 12.2.1.1 ). 2. Unfasten the two springs and remove the cover. 3. Remove runner. 4. Remove dust screen....
Checking and adjusting the ignition timing The distance between the mark in. m. t. and ignition timing mark on the flywheel a = 7; 3 mm to the left of w.m.t. - KF engine (3°to w.m.t.); a = 14; 5 mm to...
Checking the ignition coil The ignition coil fails very rarely. Check the coil with an ohmmeter, measuring the resistance of the primary and secondary windings. Order of execution 1....
Checking the Switch The switch is checked with a working ignition coil. Order of execution 1. Disconnect block block (1). Turn on the ignition and measure the voltage between the...
Hall sensor test The Hall sensor is checked when the ignition coil and switch are in good condition and the ambient temperature is from 0 to + 40°С. Order of execution 1....
Checking spark plugs The normal operation of the engine is largely dependent on the condition of the spark plugs. Order of execution 1. Having turned out the candles, inspect them....