Starting and Charging System Specifications Main characteristics System type - 12 oxen, negative mass Starter Type - Pre-engaged Freewheel Battery Capacity - 88 - 90 Ah (depending on model and market)...
General description and precautions General description 1. The engine electrical system mainly consists of starting and charging systems. Since the functions of these systems are related to the...
Battery — testing and charging Standard Battery - Test 1. If the vehicle has a low annual mileage, check the electrolyte density every three months to determine the condition of the battery....
Battery — removal and installation Withdrawal 1. On models without an air conditioner or pollen filter for the ventilation system, the battery is located in the left rear of the engine...
Alternator/Charging System — In-Vehicle Check 1. If the charging indicator lamp does not light when the ignition is on, first check the reliability of the generator wiring connection. If the wiring is...
Generator — removal, reassembly and installation Withdrawal 1. The generator can be located in front, on the right or left side of the engine (depending on its type) and is driven by a belt from a pulley at...
Launch System — Check Note: Before you start, see «Precautions», data in Chapter 1 of this Section. 1. If the starter does not work when the ignition key is turned to the working...
Starter — removal and installation Withdrawal 1. Disconnect the negative cable from the battery ( see chapter 3 ). 2. Apply the handbrake, then jack up the front of the vehicle and place it on...
Starter — check and overhaul 1. Mark the alignment of the casing and the suspension of the installation (where available) relative to each other. 2. Unscrew the nuts, remove the end of the...