Car automatic gearbox Audi 100 C3, petrol

Detailed technical specifications of automatic transmission
The automatic transmission has three forward gears and one reverse gear. It is combined with the differential, main gear and is located behind the engine. Gear...

Tightening torques for main threaded connections
Tightening torques of main threaded connections, kgf·m Gearbox to engine block mounting bolt: 5.5. Nut of the bolt securing the suspension bracket to the...

Automatic transmission parts
Automatic transmission housing parts: 1 - differential housing; 2 - clutch housing; 3 - bearing of the main gear drive pinion; 4 - lower cover of the clutch...

Removal and installation of automatic transmission
The automatic transmission is removed from underneath the vehicle using a lift. Removal Place the car on a lift. Disconnect the wire from the negative terminal...

Torque converter
The torque converter is rigidly connected at three points to the leading flange of the crankshaft flywheel. It rotates together with the flywheel and transmits...

Checking the torque converter
The design of the torque converter is non-disassemblable and cannot be repaired. By visual inspection determine the condition of the hub and, above all, the...

Automatic transmission control mechanism parts
Gear shift control mechanism for automatic transmissions of vehicles produced since August 1988: 1 - selector lever handle; 2 - bracket; 3 - protective cover;...

Adjusting the throttle control cables
As a result of this adjustment, the throttle valve should be in the closed position when the accelerator pedal is not pressed, and the gear shift control lever...

Adjusting the gear shift control mechanism
Set the selector lever to position "P". Loosen the cable clamp nut on the selector lever. Pull the gearshift control lever to the stop corresponding to the "P"...

Adjusting the 2nd gear brake band
Make sure that the automatic transmission is in a strictly horizontal position. Loosen the lock nut and adjusting bolt. Apply sealant to the bolt and tighten...

Checking the electromagnetic switch of the selector lever lock
Remove the selector lever handle. Remove the lever bracket. Remove the protective cover. Set the selector lever to the "R" position. Insert a 1mm thick flat...

Installing the electromagnetic switch for locking the selector lever
When replacing the switch, first secure the lever with a 4 mm diameter rod. Selector lever mounting: 1 - lever, 2 - rod with a diameter of 4 mm

Removal and installation the inner joint of the front wheel drive shaft
Removal Remove the wheel drive shaft as described above. Remove the sealing gasket. Remove the retaining ring. Remove the clamp and remove the protective...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

100(C4, 1990-1994)

100(C4, 1990-1994, petrol)

100(C3, 1982-1990)

100(C3, 1982-1990, petrol)

100(C3, 1982-1990, diesel)