Table of contents: Removal ↓ Installation ↓
Removal
Remove the wheel drive shaft as described above.
Remove the sealing gasket.
Remove the retaining ring.
Remove the clamp and remove the protective cover.
Press the cap using a mandrel.
Press the inner constant velocity joint off the shaft using a mandrel.
Installation
Place 90 g of "G6" type grease into the joint.
Using a press, press the constant velocity joint onto the shaft until it stops.
Install the retaining ring.
Replace the cap.
Install the protective cover.
Install a new clamp.
Install a new sealing gasket.
Install the wheel drive pivot shaft in place.