Specifications of the brake system The car is equipped with a dual-circuit brake system: one circuit brakes the left front and right rear wheels, and the other brakes the right front and left...
Adjusting the position of the brake pedal Order of execution 1. The position of the brake pedal is regulated by the length of the push rod of the master cylinder, which should be 249 mm (1 - pusher, 2...
Front wheel brake mechanism of the Teves brand Teves brake caliper 1 - the base of the bracket; 2 - protective cover; 3 - piston; 4 - sealing ring; 5 - bracket body; 6 - rubber bushing; 7 - plastic sleeve;...
GIRLING brand front wheel brake GIRLING brand front wheel brake 1 - block with wires of the brake pad wear sensor; 2 - bolt; 3 - bracket body; 4 - guide pin; 5 - bolt; 6 - base of the...
Brake disk Checking the condition of the working surfaces of the brake disc 1. Raise the front of the car and remove the wheel (cm. subsection 10.4 ). 2. Clean the brake...
Caliper body and piston Teves brake caliper 1 - the base of the bracket; 2 - protective cover; 3 - piston; 4 - sealing ring; 5 - bracket body; 6 - rubber bushing; 7 - plastic sleeve;...
Brake drum The brake drum is assembled with the wheel hub and in fact they are one piece. Removal and installation of the brake drum, see subsection 8.2.3 . Inspection...
Pressure regulator Examination To check the operation of the pressure regulator, press and quickly release the brake pedal (the vehicle must be on wheels). The assistant at this...
Parking brake adjustment Models with rear drum brakes. Order of execution 1. Check the installation of the parking brake lever, which must be in the lowest position. Raise and support...
Bleeding the brake system Warning: This operation is carried out by two people, in compliance with safety regulations, as the brake fluid is toxic. The sequence for pumping the entire...