The device of the five-cylinder engine Five-cylinder engine 1 - camshaft drive belt; 2 - top camshaft drive cover; 3 - lower camshaft drive cover; 4 - rear camshaft drive cover; 5 - camshaft gear; 6...
Removal and installation of the engine Order of execution 1. Disconnect wire from «negative» battery terminals. 2. Remove the hood (see pp. 1-6 subsection 11.3 ). 3. Drain coolant (cm. pp. 1–3...
Adjusting and tensioning the camshaft drive belt Adjusting and checking the tension of the camshaft drive belt 1 - camshaft drive belt tensioner; 2, 3 - wrenches; 4 - camshaft gear; 5 - camshaft drive belt; 6...
Removing the camshaft and valve lifters Order of execution 1. Remove cylinder head (cm. pp. 1–12 of subsection 3.2.2 ). 2. Remove bolt 12 (see fig. Cylinder head, camshaft and valves ) and remove the...
Installing the camshaft and valve lifters Order of execution 1. Lubricate tappets 19 (see fig. Cylinder head, camshaft and valves ), cams and camshaft journals with 18 engine oil. 2. Install adjusting...
Removal and installation of valves Counting from the camshaft drive, valves No. 1, 3, 6, 8, 10 are exhaust, valves No. 2, 4, 5, 7, 9 are inlet. Order of execution 1. Using a special tool,...
Disassembly and assembly of the camshaft drive Camshaft Drive Parts 1 - generator drive belt; 2 - vibration damper; 3 - lower camshaft drive cover; 4 - top camshaft drive cover; 5 - camshaft drive belt; 6 -...
Removal and installation of a flywheel Flywheel, crankshaft, oil pump 1 - oil pump; 2 - oil pump gasket; 3 - cylinder block; 4 - seal holder gasket; 5 - gland holder; 6 - rear crankshaft seal; 7 -...
Removal, check and installation of the oil pump Order of execution 1. Remove the camshaft drive belt and vibration damper with crankshaft gear (cm. pp. 2–5 of subsection 3.2.2.7 ). 2. Remove oil pan (cm....
Replacing the crankshaft seals Order of execution 1. Oil seal 16 (see fig. Flywheel, crankshaft, oil pump ) removed with a special tool. If there is no tool, remove the oil pump and remove...
Crankshaft and connecting rod and piston group The connecting rod and piston group and the crankshaft are disassembled and installed in the same order as on a four-cylinder engine (cm. subsection 3.1.2.15 ,...