Car engine repair Audi A3 8L

Engine specifications
Warning: Individual characteristics are also given in the text of the Chapter and, if their implementation is mandatory, are highlighted in bold. Engine...

Checking the compression in the engine cylinders
Compression gives an idea of the engine's condition. The test results show whether the engine needs to be replaced with a new one or whether it requires a...

Checking the engine with a vacuum gauge
Basic positions and fluctuations of the vacuum gauge needle when diagnosing engine faults Using a vacuum gauge, you can get information about the condition of...

Removal and installation the lower engine compartment cover
Removal Warning: Lifting and installing the vehicle on stands is dangerous! Therefore, before carrying out the operation, read the subsection Jacking and...

Removal and installation of engine / manual transmission
Engine 1.8 l The engine together with the manual transmission is removed downwards. A crane is required to remove the engine/manual transmission unit. No way...

Setting the piston of the first cylinder to TDC (petrol)
Four-cylinder petrol engines 1.6, 1.8 l. 1. Remove the upper timing belt cover. 2. Mark the direction of its rotation with a felt-tip pen. The motor, when...

Removal, installation and tensioning the timing belt (petrol)
Four-cylinder petrol engines 1.6, 1.8 l. Timing belt drive components. 1.6L engine shown 1 bolt, 45 Nm 2 engine holder 3 bolt, 25 Nm 4 holder 5 Upper timing...

Removal and installation the cylinder head (petrol)
Four-cylinder petrol engines 1.6, 1.8 l. Cylinder head (1.6L engine) 1 bolt, 15 Nm 2 bolt, 20 Nm 3 rear toothed belt cover 4 cylinder head 5 cylinder head...

Removal and installation a ribbed V-belt (petrol)
Four-cylinder petrol engines 1.6, 1.8 l. The ribbed V-belt is wider than the regular V-belt and has several longitudinal ribs. The ribbed V-belt drives the...

Toothed belt drive of diesel engine
1 bolt, tightening torque: 120 Nm + 1/4 turn (90°) The bolt must be replaced. The Audi-3039 holding tool is required for loosening and tightening. 2 bolt,...

Removal and installation a toothed belt (diesel)
Warning: Operations and related instructions applicable to all engines are given in subsection Removal, installation and tensioning the timing belt . This...

Removal and installation the cylinder head (diesel)
Cylinder head. Diesel engine 1 cylinder head gasket. Pay attention to the marking. 2 bolt, 20 Nm 3 cylinder head. Not subject to processing. 4 eyelets 5...

Removal and installation V-belt (diesel)
The ribbed V-belt is wider than the regular V-belt and has several longitudinal ribs. The ribbed V-belt drives the generator, power steering oil pump, radiator...

Measuring cylinders
To measure the cylinders, you need to use a special pointer gauge, which can be used to measure the top, middle and bottom of the cylinder. If you do not have...

Checking, assembling and installing the connecting rod and piston group
1. All parts should be carefully checked. If parts show signs of grooves, gouges or wear, they should be replaced. The following checks should be made for...

Checking the crankshaft
1. Carefully inspect the crankshaft for damage and take precise measurements of the main and connecting rod bearing journals. The main bearing journals and...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: