Car fuel injection system Audi A3 8L

Fuel injection system device (petrol)
Simos Engine Management System Components Location. 1.6L Engines 1 connector. For Hall sensor (black) 2 Hall sensor. Under the upper timing belt cover 3 oxygen...

Removal and installation of fuel lines and injectors (petrol)
Fuel distribution line with injectors 1 locking bracket. Ensure correct position on injector and line. 2 grid 3 fuel pressure regulator 4 sealing ring. Replace...

Checking and adjusting idle speed / ignition timing / CO concentration
As part of maintenance, adjustment of idle speed, ignition timing and CO concentration is not required, since these parameters are set by the control system...

Diesel engine injection system
When a diesel engine is running, clean air is sucked into its cylinders and compressed to high pressure. The air temperature rises to 700-900°C, exceeding the...

Direct injection device (diesel)
Location of fuel system components in the TDI engine compartment 1 exhaust gas recirculation system valve 2 suction flap bypass valve 3 nozzle with needle...

Removal and installation of injectors (diesel)
Damaged injectors can cause strong shocks during engine operation, reminiscent of an engine with damaged bearings. If such phenomena occur, run the engine at...

Checking and adjusting the injection start of the high-pressure fuel pump
Audi requires that the injection start be checked on a running engine using an electronic tester. Since the specified device may not be available, the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: