Execution order
1. Remove the distributor (see subsection 12.2.1.1).
2. Unfasten the two springs and remove the cover.
3. Remove the runner.
4. Remove the dust shield.
5. Mark the position of the anchor relative to the distributor shaft, remove the anchor and the mounting pin.
6. Loosen the screws and remove the vacuum corrector.
7. Loosen the screw and remove the Hall sensor from the socket.
8. Remove the screws and remove the fixed plate with the gasket.
9. After disassembling, clean all parts and components from dust and dirt.
10. Inspect the cover from the inside. If there are cracks or burnt contacts, the cover must be replaced. Check the condition of the contact carbon with the spring.
11. Create a vacuum in the vacuum corrector. Under the action of the vacuum, the vacuum corrector rod should move. If this does not happen, then the diaphragm is torn and the vacuum corrector must be replaced.
12. Assemble the ignition distributor in reverse order.
[The original version of the article is posted on the website: audimanual]