Ignition distributor runner (Audi A6 C4)

Replacement

1. Remove the distributor cap.

2. Remove the rotor from the distributor shaft (ACE engine).

3. Install the new runner onto the axle.

4. Check the condition of the lid and coal.

(The original article is posted on the resource: AUDImanual.ru)

The article was checked by auto expert Georgy Rodionov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A6 C4: Ignition system

Ignition system sensors
Adjusting the ignition timing angle
Ignition distributor
Ignition coil

Ignition system (6-cylinder engines 2.6 and 2.8 l)
Technical characteristics of the pre-heating system
Glow plugs of the pre-heating system

Similar articles on other Audi car models:
Electrical diagram of the Hall sensor, ignition coil with… Audi 80 B4 (1991-1996)
Ignition distributor Audi 100 C4 (1990-1994, petrol)
Ignition switch and engine start Audi A3 Type 8L (1996-2003)
Ignition distributor Audi A4 B5 (1994-2001, petrol)
Ignition switch Audi A8 D2 (1994-2002)
Ignition System — Control Data Audi Q5 Type 8R (2008-2017)
Removal and installation the ignition lock cylinder Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

A6(C5 AR, 1999-2005)

A6(C5, 1997-2004)

A6(C4, 1994-1997)