Car rear suspension Audi A6 C5

General information
Front-wheel drive cars AUDI A6 The rear suspension is made using longitudinal levers connected to a beam fixed to the body. A stabilizer is installed in front...

Unscrewing the upper shock absorber mount
When unscrewing the upper shock absorber mounting nut, using the AUDI-3079 or HAZET-2594 key, hold the shock absorber rod from turning (see fig. 8.5).

Removal and installation the shock absorber and spring
Front wheel drive cars Removal Unscrew the bolts that secure the upper shock absorber to the car body (see fig. 8.6). To improve access to the shock absorber...

Removal and installation rear wheel bearings/hubs
Removal Remove the two brake caliper mounting bolts (see fig. 8.9). At the same time, use a thin wrench to hold the guide pin from turning Remove the brake...

Shock absorber strut for all-wheel drive vehicles
The details of removing the shock absorber strut are not described. Only the tightening torque values for installing the following elements are given below:...

Repair of shock absorber strut
In principle, the rear shock absorber strut is disassembled in the same way as the front shock absorber strut. In this case, it is necessary to pay attention...

Checking the shock absorber
External manifestations that indicate a faulty shock absorber: prolonged rocking of the body when driving on uneven road surfaces; increasing body vibration...

Shock absorber disposal
In order for a faulty shock absorber to be used as a secondary raw material, it is necessary to drain the shock absorber fluid from it. Attention. The gas...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

A6(C5 AR, 1999-2005)

A6(C5, 1997-2004)

A6(C4, 1994-1997)