Car front suspension Audi A6 C5

General information
The front suspension of AUDI A6 cars is made using four independent levers. The elements included in the suspension soften dynamic loads, reduce body...

Shock absorber strut
Removal Directions: Mark the position of the front wheels in relation to the hubs with paint. This is necessary to reinstall the wheels in their original...

Disassembly and assembly of the shock absorber strut
Disassembly Remove the shock absorber from the vehicle. Secure the front suspension shock absorber strut in the conductor 3 (Fig. 7.11) or in a vice with soft...

Removal and installation the drive shaft
Removal Caution. Do not lower the vehicle onto its wheels with one or both drive shafts removed, as this will damage the wheel hub bearings. If it is necessary...

Disassembly and assembly of the drive shaft
Please note. Depending on the engine/gearbox installed in the vehicle, the inner constant velocity joint may be a ball or roller joint (Tripod). The roller...

Plastic protective case
Install upgraded high-quality steel clamps onto the protective cover. To fasten the upgraded clamps, the HAZET 1847 tool must be used (see fig. 7.27). Place...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

A6(C5 AR, 1999-2005)

A6(C5, 1997-2004)

A6(C4, 1994-1997)