Battery in luggage compartment (in spare wheel well) Withdrawal 18. Turn off the ignition. 19. Raise and secure the luggage compartment floor covering. 20. Unscrew the bolt 3 of the spare wheel mounting bracket...
Checking the electrolyte level in the battery Maintenance free battery Virtually maintenance-free batteries do not have screw-on cell plugs. Checking the level and density of the electrolyte for these...
Battery voltage test The battery voltage is measured using a voltmeter connected to the battery poles. 5. Disconnect the terminals of the power wires from the battery poles. The...
Checking the density of the battery electrolyte The density of the electrolyte, combined with the data obtained by checking the voltage of the battery, allows us to draw a conclusion about the degree of its...
Charging the battery Precautionary measures Do not disconnect the battery while the engine is running. Do not short circuit the battery, i.e. do not connect positive (+) and...
Storage of the battery If the car will not be used for more than 2 months, the battery should be removed and stored in a charged state. The most favorable storage temperature is from...
Battery self-discharge Depending on the vehicle configuration, the natural self-discharge of the battery is supplemented by current consumption by various control devices that...
Bosch generator — design description 10.0. Bosch generator: 1 - generator 2 - voltage regulator 3 - bolt for fastening the voltage regulator. Tightening torque -2.5 Nm 4 - protective cover of the...
Valeo generator — design description 10.0a. Generator Valeo: 1 - generator 2 - voltage regulator 3 - bolt for fastening the voltage regulator. Tightening torque - 2 Nm 4 - protective cover of the...
Generator — removal and installation Audi Aliroad vehicles are equipped with a three-phase alternator, which is driven by the crankshaft through a ribbed belt. Depending on the model and equipment...
Voltage regulator — removal and installation Withdrawal 1. Remove the generator (see relevant chapter). Bosch generator 2. Unscrew bolt 1, unscrew nuts 3 and 4 and remove protective cover 2 on the rear...
Starter — removal and installation The starter consists of a drive housing, an armature housing and a manifold housing. An armature and a collector, as well as a brush holder, are placed in the...