Car care Car wash Environmental protection laws prohibit car washing in non-designated locations. If the car is often washed in automatic car washes, the rotating...
Starting the engine using a booster battery Precautionary measures If the prescribed procedure is not followed, there is a risk of burns from acid escaping from the battery. In addition, there is a risk...
Towing a car The tow rope should only be attached to the tow hooks installed on the vehicle. 9. Remove the decorative grille that covers the hole for attaching the tow hook...
Towing to start the engine of the towed vehicle 16. It is recommended that you try to start the engine with a booster battery. Attention! Towing a car with an automatic transmission in order to start the...
Poddomkrachivanie car When working under a vehicle, it must be positioned and securely secured to two or four jack stands, unless it is on a lift. If the car is jacked up, then in...
Maintenance interval The frequency of maintenance of Audi Allroad cars is determined by the time factor or mileage. The need for maintenance is signaled to the driver by displaying...
Maintenance — work plan Maintenance must be carried out at the following intervals: vehicles without extended service intervals. Maintenance is carried out according to the messages...
Engine oil — level check and change You can take engine oil at a gas station through the guide tube of the oil level indicator using a suitable siphon. However, in this case, new oil will have to...
Oil filter — removal and installation 7.0. Oil filter. Vehicles with a 4.2 L petrol engine: 1 - sealing gasket 2 - bolt. Tightening torque - 10 Nm 3 - bolt. Tightening torque - 22 Nm 4 - oil filter...
Air Filter Replacement Element — Replacement 8.0. Air filter. Cars with petrol engine: 1 - air ducts 2 - replaceable air filter element 3 - clamp 4 - air filter cover 5 - sealing ring 6 - mass air flow...
Fuel Filter (Diesel Engine) — Condensation Drain A suitable container is needed to collect condensate. Attention! Avoid getting diesel fuel on rubber parts and especially on cooling system hoses. Remove any...
Gear Oil — Level Check Manual Transmission Attention! As part of the maintenance, it is only necessary to check the oil level in the box. Gear oil change is not required. Level check...
Coolant — level check Insufficient coolant volume is signaled by a light on the instrument panel. Despite this, the coolant level should be checked before every long trip....
Power steering — checking oil level and topping up Attention! As a rule, the oil level in the hydraulic booster should not decrease. If the level has dropped, then contact the workshop to repair the leak. If...
Front suspension and steering Check the fastening and clearance of the tie rod ends and ball bearings, as well as the condition of the dust caps of the ball bearings and the cuff of the...
Brake fluid — level check and change Level check The brake fluid reservoir is located in the engine compartment. There is a vent in the threaded lid of the tank, which must not be clogged. 14.0....
Brake pad thickness — check Attention! The thickness of the brake pads can be checked through the hole in the rim by lighting the pads with a flashlight. The inner block can be checked...
Brake lines — check 1. Jack up the vehicle and place it on jack stands. 2. Clean the brake lines. Attention! The pipelines of the brake system are made of metal and coated with a...
Spark plugs — removal and installation Withdrawal Attention! Unscrew the spark plugs only when the engine is cold or its temperature must be such that you can hold your hand on it. When removing...
Body and interior equipment In accordance with the maintenance plan, the following work must be carried out: Check the condition of the seat belts. Carry out a visual inspection of the...
Maintenance of electrical equipment In accordance with the maintenance plan, the following work must be performed. All current consumers. Check the operability of all consumers of the on-board...
Exhaust System — Visual Inspection 1. Put the car on jack stands. 2. Check up collars of fastening of system OG on firmness of landing. 3. Inspect the exhaust system by lighting it with a...
Wheels and tires — check It is very important to keep your tires in good condition and at the right pressure - tire failure at any speed is very dangerous. Tire wear is greatly...