Car maintenance Audi Q7 (4L)

Specifications — types and volumes of lubricants and fluids used
Types and volumes of lubricants and fluids used Fuel tank capacity, l 103 Fuel type for diesel models 1*, 2* Diesel fuel according to DIN EN 590 specification,...

General information about car maintenance
General information about car maintenance Serviceable components in the engine compartment: 1. Blue washer fluid reservoir cap; 2. Blue cap of the expansion...

General information about settings and adjustments
In this Manual, "settings" do not refer to a single procedure for adjusting any of the vehicle system parameters, but to a whole range of adjustments that...

Schedule of current maintenance
The schedule of current vehicle maintenance is provided in the service booklet included with it, and on models supplied to Russia since November 2012, an...

Checking fluid levels, leak control
Note: Regardless of the inspection intervals according to the maintenance schedule ( see Section 3 ), do not allow fluids to leak under the vehicle - such...

Checking the condition and replacing hoses and tubes in the engine compartment, localizing leaks
Caution: Replacement of the air conditioning system refrigerant lines must be performed at a service station or workshop with equipment for safely relieving...

Changing engine oil and oil filter
Caution: Long-term skin contact with used motor oil can be quite hazardous to health. Use barrier cream or wear rubber gloves when performing the procedures...

Servicing windshield wipers and washer fluid nozzles
1. Over time, road film accumulates on windshield wiper blades, reducing their effectiveness. Therefore, the blades should be regularly washed in a mild...

Checking the brake system
Caution: Dust from brake lining wear that accumulates on brake components may contain asbestos, which is hazardous to health. Do not blow out this dust with...

Replacing brake fluid, bleeding the brake system
Caution: Contact with brake fluid is hazardous to health. Do not suck it out with your mouth through a hose. Store brake fluid only in a container that is out...

Checking the condition of suspension and steering components
Note: Steering and suspension components should be inspected regularly as wear can cause excessive and dangerous tire wear, poor ride and handling, and...

Checking the condition of the CV joint boots of the drive shafts
1. Drive shaft boots (see illustration) are very important elements, as they protect constant velocity joints (CV joints) from dirt, water and other foreign...

Checking the condition of tires and their inflation pressure
Note: The tires and rims suitable for use on your vehicle, as well as the tire inflation pressure, are shown on the sticker located on the back of the fuel...

Checking the condition of the exhaust system
Note: Additional information about the exhaust system is available in Chapter 4 . 1. The check should be carried out on a cold engine, so it is best to do it...

Filling with AdBlue fluid (models with SCR system)
Note: AdBlue is designed to reduce nitrogen oxide concentrations in exhaust gases of diesel models equipped with a selective oxide catalyst (SCR). The nitrogen...

Replacing the air conditioning system cabin filter
1. Remove the instrument panel trim under the main glove compartment (see chapter 10). 2. Cover the floor covering in the front right footwell with paper under...

Replacing the air cleaner filter element
3.0 TDI models 1. Remove the decorative engine cover ( see Section 19 ). 2. Unhook the clamps (1 in the illustration), disconnect the MAF sensor connector (3)...

Checking and caring for your battery
Note: Please also refer to the materials Chapter 5 . The battery is located under the driver's seat. Caution: Certain safety precautions must be taken when...

Checking the condition of drive belts
Note: Replacement of the multi-ribbed accessory drive belt is described in Chapter 2 . The toothed belt is used only to drive the fuel injection pump ( see...

Maintenance of body parts, removal/installation of some covers and panels
1. Use G 000 115 A2 universal aerosol lubricant to lubricate door hinges and door/hood travel limiters, and G 052 778 A2 aerosol lubricant to lubricate lock...

Conducting a roadside inspection
1. During the test drive, perform the following checks. 2. For the engine: power, misfires, idle speed, acceleration, hot start behavior. 3. For AT: selector...

Resetting the maintenance indicator and checking the volume of soot deposits
1. These procedures require a VAS50xx/60xx diagnostic tool connected to the vehicle's diagnostic connector ( see Chapter 5 ). Resetting the maintenance...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Q7 4L(2005-2015, diesel)

Q5 8R(2008-2017)