Manual gearbox 0B2 and clutch of car Audi Q5 (8R)

Marking of the KP
Location at the checkpoint "Arrow A". MCP 0B1/2 "Arrow B". Letter designation and production date "Strelka S". Letter designation and production date on the...

Hydraulic clutch system
Follow the instructions for removing and installing the clutch master and slave cylinders. Hydraulic clutch system 1. Clutch slave cylinder: after removing, do...

Gearshift mechanism drive
Gear shift drive "Arrow A". Turning on; "Arrow B". Choice; 1. Connecting rod; 2. Push rod; 3. Shift rod; 4. Gear shift lever Removal Turn off the ignition....

Removal the gearbox — vehicles with a 2.0 l TDI engine
Set the front wheels to the straight-ahead position. Switch off the ignition. Disconnect the battery. Pump out the hydraulic oil from the power steering using...

Removal the gearbox — vehicles with a 2.0 l TFSI engine
Set the front wheels to the straight-ahead position. Turn off the ignition. Disconnect the battery. Pump out the hydraulic oil from the power steering using a...

Installation of the control unit
Note: Replace the bolts that are tightened with additional tightening. Aluminum bolts for fastening the engine to the manual transmission may be used twice....

Shaft sealing rings on gearboxes
Shaft seals "A" and "B" can only be replaced with the gearbox removed. Shaft seal rings "C", "D" and "E" can be replaced with the gearbox installed. Shaft...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: