Automatic gearbox 0B6 car Audi Q5 (8R)

Marking of the KP
Location of markings on the checkpoint The gearbox marking is located on the factory plate at the bottom of the gearbox. Depending on the model, the location...

Torque converter — removal and installation
Torque converter 1. Torque converter; 2. Carter KP; 3. Sealing ring: cuff (shaft seal); hydraulic transformer; 4. Bolt: replace; 6 pcs. Torque converter...

Electrical/electronic components and installation locations
Diagnostic connector Installation location: the diagnostic connector for the "VAS 5051B" tester is located in the driver's footwell. Mechatronics, automatic...

Selector lever cable
Selector lever cable 1. Selector cable retaining clip on the shift actuator functional unit; 2. Bolt: 8 Nm; 2 pcs.; 3. Gear selector cable: do not bend or...

Removal the gearbox — vehicles with a 3.2 l FSI engine
Set the front wheels to the straight-ahead position. Turn off the ignition. Disconnect the battery. Remove the rear engine cover "arrows". Remove the front...

Checking and adjusting the ATF level
The gearbox must not be in emergency mode. Place the car on a lift or in a pit so that it stands horizontally. The selector lever is in position "P". To engage...

ATF drain and ATF refill after repair
The engine is switched off. Place the car on a lift or in a pit so that it stands horizontally. The selector lever is in position "P". To engage the...

ATF radiator and ATF lines installation diagram
ATF radiator and ATF lines installation diagram 1. ATF radiator: built into the liquid coolant radiator; 2. Sealing ring: replace; lubricate with ATF before...

ATF oil pan, ATF mesh filter and Mechatronics
Caution! Risk of damage to the gearbox. Do not start the engine if there is no ATF in the gearbox or ATF oil pan. A dirty or faulty mechatronic system must be...

Removal the ATF pan
Remove the tunnel cross member. Unscrew the nut "1" of the hydraulic line of the power steering. Risk of damage to chassis parts. If the support of the power...

Removal the ATF mesh filter
Remove the ATF oil pan. Carefully remove the ATF mesh filter "A" from the gearbox. Installation The sealing ring "A" of the ATF mesh filter usually remains in...

Filling transmission oil into the front final drive after repair
The front main gear cover was removed, and because of this all the transmission oil leaked out. Put the car on a lift or in a pit so that it stands...

Checking the level and topping up the transmission oil in the transfer case
Transmission oil temperature approx. 20?C (room temperature). Place the car on a lift or in a pit so that it stands horizontally. The gearbox must remain...

Front main gear
Front main gear 1. Sealing ring of the left shaft with flange: between the main gear and the gearbox housing; 2. Adjusting washer: Behind the outer ring of the...

Central differential housing
Caution! Risk of damage to the gearbox. Do not start the engine or tow the vehicle without the limited-slip center differential or without transmission fluid....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Similar sections of other Audi car models:
Transmission: Automatic transmission 0B6 Audi A4 B8 (2007-2015)

Share information:

Q7 4L(2005-2015, diesel)

Q5 8R(2008-2017)