Front final drive 1. Seal left shaft ring with flange: between the main gear and gearbox housing; 2. Adjusting washer: behind the outer ring of the tapered roller bearing; 3. Tapered roller bearing outer ring; 4. Bolt: 11 pcs; 5. Seal right shaft ring with flange; 6. Right shaft with flange; 7. Retaining ring: replace; 8. Threaded plug for oil filler hole; replace; 35 Nm; 9. Front main gear cover: pay attention to the presence of centering bushings; 10. Adjusting washer: behind the outer ring of the tapered roller bearing; 11. Tapered roller bearing outer ring; 12. Seal front final drive cover ring; 13. Differential; 14. KP; 15. Spacer pin; 16. Shift shaft lever; 17. Switch shaft seal; 18. Left shaft with flange; 19. Bolt: 10 Nm + 45°; 20. Bearing shield: fixed together with the bearing above the stopper on the left shaft with a flange; designated as left shaft support bracket with flange; 21. Bearings: for left shaft with flange; 22. Left shaft bearing fuse with flange; 23. Cuff (shaft seal) torque converter; 24. Torque converter
Front axle final drive cover - tightening torque and sequence 1. Pre-tighten bolts -1- and -2- to a torque of 3 Nm; 2. Tighten the bolts in sequence -1...11- to a torque of 23 Nm
Visitor comments