Gluing the rearview mirror with glue
Warning. The adhesive used to attach the rearview mirror is toxic, so follow the manufacturer's instructions. The gluing of the mirror is carried out at a temperature not lower than 20°C.
Make sure that the inside of the windshield where the mirror is to be installed is completely dry.
Degrease the mirror installation site with denatured alcohol.
Let the surface dry.
Apply two drops of glue to the mating surface of the mirror base.
Following the correct orientation of the mirror, firmly press it against the glass and hold it in this position for 1 minute.
If the mirror is peeled off:
- thoroughly clean the surface of the windshield in the place of gluing the mirror from adhesive residues (e.g. with a safety razor blade);
- repeat the operation of gluing the mirror in the above order.
Sticking the rear view mirror with an adhesive tablet
Degrease the place of gluing the rear-view mirror to the glass and the mating surface of the base of the mirror with denatured alcohol.
Allow surfaces to dry.
Remove the protective film from one side of the tablet and press the tablet to the base of the rear-view mirror
Remove the protective film from the other side of the tablet.
Following the correct orientation of the mirror, firmly press it against the glass and hold it in this position for 1 min.
Visitor comments