Withdrawal
Loosen the spoiler.
Remove the plastic fender.
Remove headlight and bumper (see above).
Remove turn signal.
Remove the two lower front mounting bolts.
Remove the nine top wing mounting bolts.
Upper front fender mount
Remove the two lower rear mounting bolts.
Loosen the bolt of the inner (in the wheel well) rear mount.
The arrows show the inner bolts of the front fender
Take off the wing.
Installation
Apply a layer of sealant along the entire length of the mating surfaces.
Put the roof in place.
Fit the fixing bolts.
Adjust the gap between the fender and the door, as well as between the fender and the hood.
Tighten the bolts.
Cover the inner surface of the wing, especially in its front part, with anti-noise mastic.
Visitor comments