2. Jack up the front of the car. Remove the corresponding front wheel.
3. Loosen and remove the suspension ball joint clamp bolt and nut.
4. Disconnect the ball joint from the suspension strut.
5. Unscrew and remove the inner mounting nut and bolt, remove the lever from the lower frame.
6. To replace the rubber bushing of the inner mount, press out the bushing and insert a new one. The outer ball joint is part of the arm and if it is worn out, the entire arm must be replaced. The dust cap can be replaced separately.
7. Installation is carried out in the reverse order, tighten all nuts and bolts to the tightening torque specified in Specifications. Install the anti-roll bar as described in Chapter 6.
[Material republished from the website: AUDImanual]