2. Remove the brake disc from the hub.
3. Unscrew the screws and remove the mudguard.
4. Support the suspension strut with the hub cover from below, push out the hub. The inner bearing race will remain on the hub, so once removed, the bearing cannot be reused. Use an extractor to remove the inner race from the hub.
5. Remove the retaining rings. Support the suspension strut and push out the bearing.
6. Clean the recess in the casing and lubricate it with grease.
7. Install the outer snap ring, support the stand and press the new bearing in by pressing a metal pipe onto the outer ring.
8. Install the inner snap ring.
9. Place the hub with the bearing shoulder pad up, press the bearing and housing, pressing with a metal pipe on the inner ring.
10. Install the mudguard and brake disc, install the front suspension strut as described in Chapter 3.
