Table of contents: Heated seats ↓ Automatic adjustment of front seats ↓ Computer device (memory) for… ↓
1 - Longitudinal adjustment
Pull the handle up and move the seat to the desired distance. Release the handle and lock it.
Caution: For safety reasons, front seat adjustments should only be made when the vehicle is stationary.
2 - Backrest tilt adjustment
It is carried out by rotating the rotary adjustment handle.
Note: When driving, the backrest should not be reclined too far back - this position significantly reduces the protective effect of the seat belts.
3 - Seat height adjustment
To do this, move your body's center of gravity forward and pull the lever up. Use your body weight to set the desired height and release the lever.
Heated seats
When the ignition is on, the front seat cushions and backrests can be heated.
Automatic adjustment of front seats
The electric adjustment drive switches are located on the outer side of the seat body.
Electric adjustment of the seats is also possible when the ignition is off.
Warning: Since electric adjustment can be carried out with the ignition off, do not leave children in the car unattended. Careless switching on or uncontrolled automatic adjustment can lead to injuries.
Switch "A"
Position "up" - the seat cushion rises at an angle forward. Position "down" - the seat cushion falls at an angle forward.
Switch "B"
It regulates the longitudinal position and height of the seat. To do this, simply set it to the appropriate position indicated by the arrows. See the figure.
Switch "C"
Press "up" - the seat cushion rises at an angle backwards.
Press "down" - the seat cushion lowers backwards at an angle.
Switch "D"
The switch adjusts the angle of the backrest and the height of the headrests.
Adjusting the backrest angle
Press forward - the backrest folds. Press back - the backrest reclines.
Adjusting the height of the headrests
Press up - headrests move up.
Press down - the headrests move down.
Computer device (memory) for automatic seat adjustment
The driver's seat is additionally equipped with a small computer device with memory of 4 different positions. The computer control buttons are located in the door armrest. Switching on is done by pressing the "ON/OFF" button on the "ON" side. Switching off and blocking any position 1-4 is done by pressing the button on the "OFF" side. In this case, the data stored in the memory is not erased.
The presence of a computer does not replace automatic adjustment from the remote control on the side of the seat body.
Entering a program into the computer's memory
Set the required seat position. Press the "Memory" key and one of the four buttons at the same time. The selected seat position is stored in the memory for this button and will be set automatically by pressing it. Any subsequent programming for this number will automatically erase the previous data.
Seat adjustment via computer
It is carried out with the driver's door open or no later than 15 seconds after it is closed. To do this, briefly press the button with the corresponding number, behind each of them - one of the programmed positions, and the seat is automatically set to this position.
If the time after closing the door has exceeded the specified 15 seconds, the procedure is the same, only the button with the selected number is pressed and held until the programmed position of the driver's seat is fully set.
[The original article is available on the online resource «audimanual»]