General description AUDI 80 is available with two body styles - «sedan» And «station wagon» (Avant models). The smooth connection between the front and rear bumpers and the body...
Front bumper — removal and installation Withdrawal 1. Open the hood. 2. Remove the engine mudguard (see illustration). 3. Turn out on the back side of a bumper a bolt with a cross-shaped slot which...
Mudguard engine and grille — removal and installation Engine mudguard The mudguard of the engine provides a good streamlining of the body and performs the role of sound insulation. When performing many work on the...
Hood — removal and fitting Withdrawal 1. Mark the mounting position of the hood hinges if the hood is to be reinstalled. 2. Disconnect the wire of the engine compartment light, the wire...
Wings — removal and installation Only the front fenders can be dismantled. 1. Remove the wheel whose fender is to be removed. 2. Remove the plastic plug at the lower rear end of the bumper. 3....
Doors A feature of AUDI 80 cars are two-piece doors. The inner part, on which the door elements are attached, is connected to the outer part of the door with four...
Exterior mirrors Withdrawal Power outside mirrors 1. Move the mirror housing to the side. This will provide access to the mounting bolts. 2. Disconnect the multi-pin plug next...
Trunk lid — removal and fitting Cars with a body «sedan» Withdrawal 1. Raise the trunk lid. 2. Move the trunk upholstery over the left rear light and disconnect the boot light plug. 3....
Rear folding door Avant cars Removal and installation 1. Remove an upholstery of a back folding door. 2. Disconnect the plugs, the hose of the central lock and the hose of the...
Rear bumper — removal and installation Cars with a body «sedan» 1. Turn up the floor mat in the trunk. Vehicles with Avant body 2. Remove facing of the lock. 3. Raise the floor mat. 4. Disconnect...
Dashboard and center console The left lower overlay of the instrument panel - removal and installation The left lower overlay of the instrument panel is also a shelf for storing small...
Seats Front seat - removal 1. Remove the trim tabs on the inner seat slide rail, and push the trim back off the rail. Seats with manual adjustment 2. Remove the...