Internal elements of the car body Audi 80 B3, petrol

Upholstery and carpets — maintenance
It is recommended to regularly vacuum the mats from sand. If they are very dirty, they are taken out of the car for washing and cleaning. When dry, they are...

Door trim panel — removal and installation
1. Open the door, lift it up and unscrew the screws from the hinge plate (photo). 2. Press the finger panel forward and remove it from the trim panel. Remove...

Door lock — removal and installation
1. Remove the door trim panel ( Chapter 14 ). 2. Disconnect the lock release button and the outer handle lever linkage from the lock. 3. Unscrew the lock...

Window lifter (Sedan) — removal and installation
1. Remove the door trim panel ( Chapter 14 ). 2. Mark the exact position of the mounting plate relative to the door panel, then remove the mounting bolts, two...

Window lifter (Coupe) — removal and installation
1. The procedure is similar to that for the model Sedan , but differs in detail, as shown in Fig. 11.13.

Seat belts — removal and installation
1. The seat belt attachment points are shown in Fig. 11.24. 2. Access to the mounting points of the central pillar is obtained by removing the rear seat...

Center console — removal and installation
1. Raise the parking brake lever, then use a screwdriver to remove the trim panel from under the lever. Insert the screwdriver through the parking brake lever...

Instrument panel — removal and installation
1. Remove the instrument panel ( Section 12 ) and the center console ( Chapter 28 ). 2. Using pliers, carefully remove the heater control knobs (photo). 3....

Central section of the instrument panel — removal and installation
1. Remove the center console ( Chapter 28 ). 2. Using pliers and a spacer, carefully remove the control knobs from the heater. 3. Remove the screws and take...

Seats — removal and installation
Front seat 1. Move the seat all the way back and remove the front mounting bolt (photo). 2. Move the seat all the way forward and unscrew the rear fastener...

Central locking system — general information
1. Some models are equipped with a central locking system that automatically locks all doors in unison with the manual locking of any front door. The system is...

Electric windows — general information
1. Electric windows are installed as standard in some Audi 80, 90 and Coupe models, and can be installed as special order equipment on other models, the...

Heater — removal and installation
1. Disconnect the negative battery cable. 2. Using pliers and a spacer, carefully remove the heater control knobs. 3. Remove the screws and remove the panel....

Heater blower unit — removal and installation
1. Unscrew the bolts from the bottom of the glove compartment, then remove it. 2. Disconnect the wire contact from the connecting strip on the heater casing...

Air Conditioning System — Precautions and Maintenance
1. Never disconnect any part of the air conditioning refrigeration circuit unless the system has been discharged by your Audi dealer or specialist. 2. If the...

Air Conditioner Fan Unit — Removal and Installation
1. Unscrew the bolts from the bottom of the glove compartment, then remove the glove compartment. 2. Disconnect the electrical wiring. 3. Loosen the mounting...

Air Conditioning Compressor Magnetic Clutch — Adjustment
1. The air conditioning compressor is activated by a magnetic clutch which is part of the drive belt pulley. Normally the clutch does not need adjustment, but...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

80(B4, 1991-1996)

80(B3, 1986-1991)

80(B3, 1986-1991, petrol)

80(B2, 1979-1986)