Car clutch repair Audi 80 B3, petrol
Clutch specifications
Type - Single disc, pressure plate with diaphragm spring, hydraulically controlled Friction disc Diameter - 210.0 mm Clutch housing Maxim, wear depth of...
Type - Single disc, pressure plate with diaphragm spring, hydraulically controlled Friction disc Diameter - 210.0 mm Clutch housing Maxim, wear depth of...
General description of the clutch
Clutch: single-disc, engaged by a pressure plate with a diaphragm spring, with hydraulic control. The clutch housing is bolted to the rear surface of the...
Clutch: single-disc, engaged by a pressure plate with a diaphragm spring, with hydraulic control. The clutch housing is bolted to the rear surface of the...
Clutch Maintenance
Perform the following procedures at the intervals given in " Technical maintenance " at the beginning of the guide. Checking for leaks and condition of...
Perform the following procedures at the intervals given in " Technical maintenance " at the beginning of the guide. Checking for leaks and condition of...
Clutch pedal — removal and installation
1. Remove the lower panel from under the steering column ( Section 11 ). 2. Remove the bracket, remove the pin securing the master cylinder push rod to the...
1. Remove the lower panel from under the steering column ( Section 11 ). 2. Remove the bracket, remove the pin securing the master cylinder push rod to the...
Clutch hydraulic system — bleeding
1. If necessary, raise the front of the vehicle and support it on axle stands to improve access to the bleed screw on the slave cylinder. 2. Remove the rubber...
1. If necessary, raise the front of the vehicle and support it on axle stands to improve access to the bleed screw on the slave cylinder. 2. Remove the rubber...
Clutch slave cylinder — removal, overhaul and installation
1. The slave cylinder is secured to the clutch housing with a single bolt. Although access is possible from the engine bay, access is best achieved by raising...
1. The slave cylinder is secured to the clutch housing with a single bolt. Although access is possible from the engine bay, access is best achieved by raising...
Clutch Master Cylinder — Removal, Overhaul and Installation
1. The clutch master cylinder is located in the engine compartment, on the front side of the bulkhead. 2. From inside the vehicle, remove the lower panel from...
1. The clutch master cylinder is located in the engine compartment, on the front side of the bulkhead. 2. From inside the vehicle, remove the lower panel from...
Clutch — removal, inspection and installation
1. Access to the clutch can be gained by removing the engine ( Section 1 ) or gearbox ( Section 6 ). If engine repair is not required, it is preferable to...
1. Access to the clutch can be gained by removing the engine ( Section 1 ) or gearbox ( Section 6 ). If engine repair is not required, it is preferable to...
Release bearing and lever — removal and installation
1. Use a screwdriver to remove the studs with a ball end on the gearbox housing. If this is difficult to do, first push the spring from the release lever....
1. Use a screwdriver to remove the studs with a ball end on the gearbox housing. If this is difficult to do, first push the spring from the release lever....
Troubleshooting Clutch Problems
Intense vibration The friction disc linings are contaminated with grease Loose or worn engine/gearbox mounting brackets The gearbox input shaft or the friction...
Intense vibration The friction disc linings are contaminated with grease Loose or worn engine/gearbox mounting brackets The gearbox input shaft or the friction...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar sections of other Audi car models:
Transmission: Clutch Audi 100 C4 (1990-1994)
Transmission: Clutch and drive shafts Audi A3 Type 8L (1996-2003)
Transmission: Clutch Audi A4 B5 (1994-2001)
Transmission: Clutch Audi A6 C4 (1994-1997)
Transmission: Clutch Audi A8 D2 (1994-2002)
Transmission: Clutch Audi 100 C4 (1990-1994)
Transmission: Clutch and drive shafts Audi A3 Type 8L (1996-2003)
Transmission: Clutch Audi A4 B5 (1994-2001)
Transmission: Clutch Audi A6 C4 (1994-1997)
Transmission: Clutch Audi A8 D2 (1994-2002)
Share information:
- General information
- User manual
- Maintenance
- Troubleshooting
- Power unit
- Engine
- Cooling system
- Heating and ventilation
- Petrol injection
- Diesel fuel system
- Fuel system
- Exhaust systems
- Ignition system
- Transmission
- Clutch
- Car gearbox
- Chassis
- Brake system
- Suspension and steering wheel
- Body
- Body and trim
- Electrical equipment
- Electrical system
- Electrical circuits
- General information
- Repair characteristics
- Maintenance
- Power unit
- Gasoline engine
- Diesel engine
- Engine lubrication system
- Fuel system (gasoline)
- Injection system (gasoline)
- Fuel system (diesel)
- Ignition system
- Cooling system
- Heater
- Exhaust system
- Transmission
- Clutch and gearbox
- Chassis
- Steering
- Brake system
- Car suspension
- Body
- Body elements
- Electrical equipment
- Power devices
- Lighting and appliances
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Engine 4-cylinder
- Engine 5-cylinder
- Cooling system
- Fuel and exhaust systems
- Ignition system
- Transmission
- Clutch
- Mechanical transmission
- Automatic transmission
- Drive shafts
- Chassis
- Brake system
- Suspension
- Steering
- Body
- Exterior
- Interior
- Electrical equipment
- Equipment and devices
- Electrical circuits