Front suspension device The load-bearing element of the front suspension is an aggregate beam fixed to the body, so that the aggregate beam can be removed with the engine and gearbox....
Removal and installation of an amortization rack Vehicles from 9/88, starting with #89JA377713 The forged steering knuckle and suspension strut are screwed together. 1 cover 2 nuts, 65 Nm Self-locking, always...
Suspension strut Vehicles from 9/88, starting with #89JA377713 1 - slotted nut, 50 Nm 2 - suspension strut support How does the spare part come with integrated ball bearing 3 -...
Removal and installation of a power shaft Withdrawal Remove wheel cover. Loosen the hub nut on the drive shaft. Attention: The car must be on the ground. Remove washer Loosen wheel bolts. Raise the...
Drive shaft Replace defective cuffs. To replace the protective covers, the drive shaft must be disassembled. If dirt gets into the grease, the hinge should be wiped off...
Rear suspension device The rear suspension of the AUDI 80/90 with front-wheel drive consists of an L-shaped profile, inside of which a torsion tube is welded. The torsion tube serves...
Shock absorber check The shock absorber can be checked manually. Remove shock absorber. Hold the shock absorber in the installation position, stretch and compress the shock...
Removal and installation of wheel bearings Withdrawal Vehicles with drum brakes: remove rear wheel and brake drum. Vehicles with disc brakes: remove the brake disc and wheel hub. Remove wheel bearing...
Wheel bearing play adjustment Loosen wheel bolts. Raise the rear of the car. Remove rear wheel. Knock off the cap with a rubber mallet or pry it off with a screwdriver. Pull out the cotter...