Vehicle suspension and steering Audi 80 B4

General description
The creation of the AUDI 80 body with a through-boot required the development of new suspensions for front-wheel drive vehicles, as well as for quattro models....

All-wheel drive quattro models
All-wheel drive vehicles are usually considered SUVs. But AUDI quattro vehicles, having a drive on all four wheels, remain representatives of their class (see...

Front suspension shock absorber strut — removal and installation
A car enthusiast is able to independently perform a fairly large amount of work related to the suspension, despite the fact that certain work requires the...

Front Suspension Shock Absorber — Replacement
To replace the shock absorber, which is only possible with the shock absorber strut removed, you will need at least two coil spring clamps. Caution! Do not...

Ball joint — replacement
1. Obtain new self-locking nuts and a new ball joint clamp bolt. 2. Place the front of the car on jack stands, ensuring that it is in a level position....

Wishbone — Removal and Installation
Removal All self-locking nuts, as well as the bolts securing the wishbone to the ball joint, must be replaced with new ones. 1. Purchase new self-locking nuts...

Rear shock absorber strut: front wheel drive vehicles
Removal 1. Place the vehicle on jack stands and ensure that it is securely supported. 2. Loosen the wheel mounting bolts and remove the wheel. 3. Place a...

Rear suspension shock absorber: quattro vehicles
Removal 1. Place the vehicle on jack stands and ensure that it is securely supported. 2. Loosen the wheel mounting bolts and remove the wheel. 3. Place a...

Rear shock absorber — removal and installation
Front wheel drive cars Before you start replacing the shock absorber, check what type of shock absorber is installed on the car. You can find out from the...

Rear Wheel Hub Bearing — Adjusting Play
Front wheel drive cars 1. Jack up the rear of the vehicle. 2. Remove the hub nut cap using a chisel. Move the chisel around the cap several times. Deformation...

Drive axle shafts
General information To turn the wheels, ball joints are located on the drive shafts (half-axles). Thus, the drive of each wheel consists of two constant...

Drive axle shafts — disassembly
Outer constant velocity joint - removal and installation 1. Remove the axle shaft. 2. Loosen the clamp securing the cuff on the faulty CV joint and move the...

Steering system
AUDI 80 cars are equipped with hydraulic power steering (servo control). The driver's efforts to control the vehicle are supported by hydraulic fluid, which is...

Steering wheel — removal and installation
The steering wheel of AUDI 80 cars can be equipped with an airbag unit. Such a steering wheel has an enlarged cover. Under which is a folded airbag. It is a...

Wheel installation
To ensure safe driving and reliable operation of the vehicle's chassis, the front wheels must be installed at a certain angle. Wheel alignment The front wheels...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

80(B4, 1991-1996)

80(B3, 1986-1991)

80(B3, 1986-1991, petrol)

80(B2, 1979-1986)