Front wheel drive of car Audi 80 B2

Design and technical characteristics
The front drive wheels are driven by two shafts, each of which has two constant velocity ball joints. The front drive shafts are made of pipe. Length of front...

Tightening torques of main threaded connections, kgf.m
Bolts securing the inner joint of the wheel drive shaft to the flange of the differential output shaft 4.5. Wheel hub mounting nut on splined shank of wheel...

Replacing the differential output shaft seal
Loosen the bolts securing the inner joint of the wheel drive to the flange of the differential output shaft and disconnect the wheel drive shaft from the...

Removal and installation front wheel drive shafts
Removal Loosen the wheel hub nut. Place the car on a lift and remove the wheel. Loosen the bolts securing the inner joint of the wheel drive shaft to the...

Removal and installation the inner joint of the front wheel drive shaft
Removal Remove the wheel drive shaft as described above. Remove the retaining ring. Shine clamp and protective cover. Press the outer cap of the joint off the...

Removal and installation the outer joint of the wheel drive shaft
Removal Remove the wheel drive shaft as described above. Remove the clamping clamps and the protective cover of the hinge. Clamp the wheel drive shaft in a...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

80(B4, 1991-1996)

80(B3, 1986-1991)

80(B3, 1986-1991, petrol)

80(B2, 1979-1986)