B4 (1991-1996) B3 (1986-1991) B3 (1986-1991, petrol) B2 (1979-1986)

Tightening torques of main threaded connections, kgf.m (Audi 80 B2)

Bolts securing the inner joint of the wheel drive shaft to the flange of the differential output shaft 4.5.
Wheel hub mounting nut on splined shank of wheel drive shaft: 23.0.
Nut of the bolt securing the lower ball joint to the front suspension arm: 6.5.
Wheel mounting bolt: 9.0.

[A link to the original source is available on the website: AUDIMANUAL.ru]

The article was checked by auto expert Georgy Rodionov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Audi 80 B2: Front wheel drive

Next articles

Design and technical characteristics

Replacing the differential output shaft seal
Removal and installation front wheel drive shafts
Removal and installation the inner joint of the front wheel…
Removal and installation the outer joint of the wheel drive shaft

Similar articles on other Audi car models:
Tightening torques for main threaded connections Audi 100 C3 (1982-1990, petrol)
Mass connections Audi A3 Type 8L (1996-2003)
Tightening torques for threaded connections Audi A4 B5 (1994-2001)
Tightening torques for threaded connections Audi A6 C4 (1994-1997)
Main reverse gear Audi A8 D2 (1994-2002)
The center differential housing is a threaded cardan shaft Audi Q5 Type 8R (2008-2017)
Ancillary Bracket — Tightening Sequence and Torque Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

80(B4, 1991-1996)

80(B3, 1986-1991)

80(B3, 1986-1991, petrol)

80(B2, 1979-1986)

This site uses cookies 🍪. Click the button to accept this fact.