Suspension and steering specifications Wheel alignment Note: Models since 1998 have been equipped with an aluminum upper wishbone mounting bracket instead of a steel one. Pay attention to the...
General information about suspension and steering 1. Front suspension - independent, with four wishbones (two lower and two upper on each side) and vertical posts (or swivel). The upper and lower arms form...
Front hub bearings — replacement Note: The double row roller bearing is lubricated, adjusted, sealed and maintenance free. Do not attempt to remove the bearing unless absolutely necessary, as...
Front suspension strut — removal and installation Withdrawal 1. Remove the decorative cap, loosen the bolts of the corresponding wheel while the car is on wheels. 2. Chock the rear wheels, apply the handbrake,...
Front anti-roll bar — removal and installation Withdrawal 1. The stabilizer must be removed and installed on a car mounted on its own wheels. To carry out this operation, therefore, it is best to install...
Front suspension subframe — removal and installation Withdrawal 1. Chock the rear wheels, apply the handbrake, raise the front of the vehicle and install jack stands. 2. Remove both front wheels. When removing...
Rear wheel bearings — adjustment 1. Place chocks under the front wheels, turn on the steam gear or "R". Raise the rear of the vehicle and install safety stands. 2. Carefully remove the...
Rear wheel bearings — replacement Withdrawal 1. The bearings are installed in the rear hub/brake disc. Detailed removal is described in paragraph 7 of chapter 9 . 2. Wipe down the inner bearing...
Rear hub axle — removal and installation Withdrawal 1. Remove the disc/hub as described in paragraph 9 . 2. Turn away bolts of fastening of a brake board. remove it along with the axle (pic. 10.2, a,...
Rear suspension strut — removal and installation Withdrawal 1. Chock the front wheels, raise the rear of the vehicle and install jack stands. Remove the corresponding rear wheel. 2. Transfer the weight of the...
Rear suspension strut — repair Attention! Rear suspension strut disassembly requires a compressor to compress the springs (spring spreader). Be careful even with a compressor - the spring is...