Electrical Equipment Specifications Cars of this brand are equipped with a 12 V electrical system with negative grounding. All lighting fixtures and electrical units are powered by a lead-acid...
Disconnecting connectors 1. (A): Push in the bar with a screwdriver (arrow on accompanying illustration), while pulling on the plug, and disconnect the connection. A distinct click...
Checking the wiper motor The wiper motor is located in the water collection area under the windshield. To check it is necessary to remove the corresponding cover. Terminal designation...
Checking the heated rear window When the heated rear window is turned on, the field with visible lines of wires should be free of coating or snow after a while. 1. If there is a problem,...
Checking brake lights 1. Check the brake light bulbs, replace if necessary. If the bulbs are OK, check the brake light switch. When the brake pedal is pressed, the switch closes and...
Removal and installation of a sound signal Warning: Two horns are located below the right and left headlights. Withdrawal 1. Disconnect the negative cable (-) battery. Warning: Follow the instructions...
Removal and installation of parking sensors Withdrawal 1. Sensors (arrows on the accompanying illustration) located in the bumper. Warning: The illustration shows the front bumper. 2. External front...
Ignition key remote control battery replacement Withdrawal 1. Open the key bit. 2. Insert a screwdriver into the recess. Turn the screwdriver and remove the transmitter housing (1) from key part (2). 3....
Relays and fuses Most of the car's electrical consumers are protected by fuses. The individual components of the lighting system, with the exception of the brake lights, are...
Removal and installation of headlights Note: The design of the halogen headlight corresponds to that of the xenon headlight. The headlight with a halogen lamp is missing only the ignition unit (2)....
Removal and installation of an additional brake light Caution: Light diodes are installed in the additional brake light. If there is damage to the light diodes, the brake light must be replaced as a set. Sedan...
Removal and installation of a back lantern Withdrawal 1. Open the hole (1) in the trunk lining. 2. Remove the screw (3) and tilt the rear light outward, while removing the ball pin from the wing. 3....
Removal and installation of the dashboard In the dashboard, only LEDs are installed as control lamps (LED). In case of damage to the LED and any other damage in the dashboard, it is replaced as a set....
Removal and installation of the light switch Withdrawal 1. Disconnect the negative cable (-) battery. Warning: Follow the instructions in Section Replacing the battery . 2. Press the light switch (arrow...
Removal and installation of the trunk lid switch Withdrawal 1. Disconnect the negative cable (-) battery. Warning: Follow the instructions in Section Replacing the battery . 2. Remove the trunk lock, refer to...
Removal and installation of the parking brake switch Withdrawal 1. Disconnect the negative cable (-) battery. Warning: Follow the instructions in Section Replacing the battery . 2. Remove the rear ashtray, refer...
Removing and installing loudspeakers High and low frequency loudspeakers are installed in the doors. 1. Disconnect the negative cable (-) battery. Warning: Follow the instructions in Section...
Removing and installing antennas Withdrawal 1. Disconnect the negative cable (-) battery. Warning: Follow the instructions in Section Replacing the battery . 2. Remove the roof end strip,...
Single lock — general information A single lock consists of a control unit and various adjustment elements with built-in electric motors. Adjusting elements in the doors are built into the lock...
CAN digital data bus The vehicle uses several CAN busses (Controller Area Network) between blocks (modules) control of various systems and controllers of executive devices of the...