Maintenance Specifications Volumes of filling oils and liquids Engine oil: Engines 1595 cm 3 (ADP, AHL) — 3.3 l All other engines - 3.9 l Cooling system: Petrol models 6.0 l Checkpoint:...
Maintenance Schedule — Gasoline Models The vehicle service intervals in this manual are based on the assumption that you will be doing all the work. Here is the minimum of work that is necessary,...
View under the hood and under the car View under the hood - models with a gasoline 20-valve engine 1.8 l DOHC (ADR) 1. Engine oil filler cap 2. Air filter 3. Carbon canister solenoid valve 4. DMRV...
Regular car maintenance 1. If after purchasing a car. If you adhere to the maintenance schedule and maintain fluid levels and wear parts as recommended in this manual, the engine will...
Auxiliary drive belt — check (15,000 km) 1. Depending on the type of engine and vehicle equipment, one, two or three accessory drive belts can be installed. The main belt drives the alternator, fan...
Checking the condition of the timing belt (15,000 km) 1. Unhook the spring clips and carefully remove the top outer cover from the front of the motor ( see paragraph 4 of chapter 2A ). 2. Check that there are no...
Resetting the service interval indicator (15,000 km) 1. Having completed all necessary maintenance procedures. the corresponding indicator readings must be reset. 2. To reinstall the indicator, Audi service...
Tire condition check (12 months) 1. Raise the appropriate part of the vehicle and install safety stands. 2. While slowly rotating the wheel by hand, check the condition of the tires as...
Lubrication of hinges and locks (12 months) 1. Lubricate hood, door and trunk hinges with general purpose grease. Also grease locks and latches. At the same time, check the reliability of the closing of...
Battery electrolyte level check (12 months) 1. If a conventional serviceable battery is installed, the electrolyte level may need to be checked and maintained. Some batteries have MIN and MAX marks on...
Reading fault codes in the engine ECU (12 months) This test can only be performed at a workshop with specialized diagnostic equipment. If a DTC is found, the fault itself must be repaired to keep the engine...
Checking leaks under the hood (12 months) 1. To gain access to the engine, remove the engine top cover. Raise the front of the vehicle and install safety stands. Visually inspect the engine mating...
Checking the concentration of antifreeze (12 months) Attention! Wait for the engine to cool down before starting the procedure. Do not allow antifreeze to come into contact with leather or painted bodywork. Wash...
Exhaust system check (12 months) 1. Let the engine cool down for at least an hour after driving. Check the condition of the exhaust system from the engine to the exhaust pipe. It is most...
Suspension and steering check (12 months) Steering and front suspension check 1. Raise the front of the vehicle with a jack and install safety stands. 2. Visually check for damage to the anthers of the...
Road vehicle checks (12 months) Control devices and electrical equipment 1. Check the operation of control devices and electrical equipment. 2. Check that all gauges are reading correctly,...
Fuel filter replacement (30,000 km) 1. The fuel filter is located under the bottom of the car, to the right of the fuel tank (fig.20.1). 2. Remember the filter setting. loosen the clamps and...
Replacing the cabin ventilation filter (30,000 km) 1. If provided, the filter is installed under the panels near the windshield, on "right-hand drive" models - on the left and on "left hand drive" models on the...
Headlight adjustment (30,000 km) Halogen headlights 1. Fine adjustment of the headlights is possible only with special optical equipment and therefore must be carried out at a dealer car...
Replacing the air filter element (30,000 km) Remove the air filter housing shield and intake duct. After unfastening the fasteners, remove the top cover of the air filter. If necessary, temporarily remove...
Replacing spark plugs (60,000 km) 1. Proper spark plug performance is essential to engine longevity. It is very important to use the type of plug that is specifically designed for use in a...
Timing belt replacement (60,000 km) The procedure is described in paragraph 4 of chapter 2A . Application: Manufacturers recommend changing the timing belt every 120,000 km, but we recommend...
Brake fluid change (every 2 years) Warning: Hydraulic brake fluid can damage eyes and painted surfaces, so care must be taken when handling and storing it. Do not use liquid that has been kept...
Coolant change (every 2 years) Drying the cooling system Warning: Wait for the engine to cool down before starting this procedure. Do not allow antifreeze to come into contact with the skin...
Exhaust gas composition check (every 2 years) This check must be carried out in accordance with the maintenance schedule. prescribed by the manufacturer implies the use of a gas analyzer. If a malfunction...