Heating and ventilation system — general information 1. The heating and ventilation system consists of an adjustable fan motor (installed under the bezel), front deflectors in the center and along the edges of...
Heating fan assembly — removal and installation 1. The information contained in this paragraph applies only to manual control systems without air conditioning. On models with air conditioning, the removal...
Heating fan motor — removal and installation 14. Disconnect the wire "masses" from the battery. 15. Remove the glove box from the front panel as described in chapter 11 . 16. On later models, remove the...
Series resistor and bimetal fuse block Removal - early models 20. Remove the glove box - see chapter 11 . The resistor/fuse block is mounted on the side of the fan housing. 21. Disconnect the two...
Heater unit — removal and installation Withdrawal 29. Before starting work, make sure that the engine is completely cool. 30. Open the hood, on the motor shield, find the connection point of the...
Heater radiator — removal and installation Withdrawal 45. Remove the heater block as described above. On models up to 1996, there is no need to remove the heater block from the front panel. 46. Having...
Outside air valve servomotor (since 1997) Withdrawal 48. Disconnect the wire from the battery "masses". 49. Remove the glove box as described in chapter 11 . 50. The servomotor is attached to the right...
Air conditioning fan motor — removal and installation Withdrawal 30. Disconnect the wire "masses" from the battery. 31. As described in chapters 11 and 12 , do the following: A) Remove the glove box from the front...
Heater fan motor control unit Withdrawal 35. Disconnect the wire from the battery "masses". 36. As described in chapter 11 , do the following: A) Remove the glove box from the front panel....
Components of the air conditioner control system Warning: Before removing components, the system must be put into the appropriate mode. This work requires the use of specialized diagnostic equipment. Contact...