Battery Charging System and Starter Specifications Total information System type - 12 V with "minus the mass" Starter Type - pre-engaged Battery Capacity — 44...80 A/h (depending on model and market) Generator...
General information and precautions General information The electrical system of the engine is mainly composed of the system for charging the battery and starting the engine. Since these systems...
Battery — check Standard and low maintenance batteries 1. If the car is rarely used, it is necessary to check the density of the electrolyte every three months to determine...
Charging standard and low maintenance batteries Note: These instructions are advisory in nature. Always follow the battery manufacturer's instructions (often printed on a sticker on the side). 9. Charge the...
Charging maintenance-free batteries Note: The procedure below is a recommendation. Always follow the manufacturer's instructions. 13. This type of battery takes longer to fully charge than the...
Battery — removal and installation Note. If the car is equipped with a radio with a secret code, before disconnecting the battery, read the section "disconnecting the battery". Disable and...
Charging system — check on the car Note. Please refer to the warnings contained in the paragraph 1 of this chapter. 1. If the warning light does not light up on the display when the ignition is...
Generator — removal and installation Withdrawal 1. Disconnect the negative cable from the battery and move it away from the terminal - read the warnings in paragraph 1 . 2. On AHL engines, remove...
Launch System — Check Note. See warnings. contained in paragraph 1 of this chapter before starting work. 1. If the starter refuses to work when the ignition key is turned to the...
Starter — removal and installation Withdrawal 1. Disconnect the negative cable from the battery terminal as described in paragraph 3 . 2. Apply the handbrake, raise the front of the vehicle and...
Starter — check and repair If there is a suspicion of a starter malfunction, it must be removed from the engine and taken to an auto electrician for welding. In most cases, it is enough...