Steering wheel — removal and installation Warning: Before starting the procedure, read the warning in chapter 12 regarding the components of the SRS system (airbags). Withdrawal 1. Remove the airbag...
Ignition lock cylinder — removal and installation Withdrawal Note: This procedure requires a spare thin head ignition key. A regular key has a head that contains an immobilizer transmitter or a flashlight, it...
Steering gear rubber boots — replacement 1. It is not necessary to remove the rail to replace the covers. 2. Measure the protruding part of the thread on the inside of the tie rod to the lock nut,...
Steering Hydraulic System — Bleeding 1. This procedure is required if system components have been disconnected or air has entered the system due to a leak. 2. Remove the cover of the reserve tank,...
Power steering pump — removal and installation Withdrawal 1. Apply the handbrake, raise the front of the vehicle and install the safety props 2. Turn away screws of fastening and remove the bottom...
Steering tip — removal and installation Withdrawal 1. Apply the handbrake, raise the front of the vehicle and install the jack stands. Remove the corresponding wheel. 2. Unscrew the adjusting bolt,...
Tie rod — removal and installation Withdrawal 1. Apply the handbrake, raise the front of the vehicle and install the jack stands. Remove the corresponding wheel. When removing the wheel, tighten...
Steering gear — adjustment 1. Stop the vehicle, turn off the ignition and turn the steering wheel from side to side. If there is play in the mechanism, accompanied by noise or knocking,...