Petrol engines 3.0 l (CAKA/CCBA/CMUA) of car Audi A4 B8
Technical specifications
Technical specifications Letter designations SAKA SSVA CMUA Working volume, l 2,995 2,995 2,995 Power, kW at rpm 245/5500...7000 245/5500...7000...
Technical specifications Letter designations SAKA SSVA CMUA Working volume, l 2,995 2,995 2,995 Power, kW at rpm 245/5500...7000 245/5500...7000...
3.0L Petrol Engine — Removal
Engine number The engine number will only be visible after removing the engine cover. compartment. Engine removal - vehicles with dual-clutch transmission 0B5...
Engine number The engine number will only be visible after removing the engine cover. compartment. Engine removal - vehicles with dual-clutch transmission 0B5...
Engine installation and replacement of cushions
Engine installation Tightening torques (Nm) Bolts and nuts M6 9 M7 15 M8 20 M10 40 M12 65 Ground bolt to the body near the shock absorber cup Tighten ground...
Engine installation Tightening torques (Nm) Bolts and nuts M6 9 M7 15 M8 20 M10 40 M12 65 Ground bolt to the body near the shock absorber cup Tighten ground...
Cylinder block from the belt pulley side
Compressor poly-V drive 1. Compressor poly-V drive: check the degree of wear; when installing, ensure correct position on the pulleys. 2. Bolt: 42 Nm. 3....
Compressor poly-V drive 1. Compressor poly-V drive: check the degree of wear; when installing, ensure correct position on the pulleys. 2. Bolt: 42 Nm. 3....
Cylinder block from the gearbox side
Slave disk 1. Driven disk: with bearing flange; check the working surfaces of the bearing mounting flange and the clutch module holes for cracks and entry...
Slave disk 1. Driven disk: with bearing flange; check the working surfaces of the bearing mounting flange and the clutch module holes for cracks and entry...
Chain drive
Chain drive covers 1. Bolt: replace. 2. Crankshaft oil seal, gearbox side. 3. Bolt: replace. 4. Guide sleeve: 2 pcs. 5. Grub screw. 6. Left cylinder head...
Chain drive covers 1. Bolt: replace. 2. Crankshaft oil seal, gearbox side. 3. Bolt: replace. 4. Guide sleeve: 2 pcs. 5. Grub screw. 6. Left cylinder head...
Cylinder head (CH) — removal and installation
Note: The illustration shows the cylinder head of cylinder bank 2 (left). 1. Cylinder head gasket; mounting position: Part number facing the cylinder head;...
Note: The illustration shows the cylinder head of cylinder bank 2 (left). 1. Cylinder head gasket; mounting position: Part number facing the cylinder head;...
Valve mechanism — removal and installation
Caution! Risk of damage to valves and piston crowns after working on the valve train. Since the hydraulic lifters must be settled, after installing the...
Caution! Risk of damage to valves and piston crowns after working on the valve train. Since the hydraulic lifters must be settled, after installing the...
Lubrication system — removal and installation
Lower part of the oil. pan, upper part of oil. sump, oil pump, engine oil cooler 1. Nut: 9 Nm. 2. Oil level and temperature sensor "G266". 3. Lip seal:...
Lower part of the oil. pan, upper part of oil. sump, oil pump, engine oil cooler 1. Nut: 9 Nm. 2. Oil level and temperature sensor "G266". 3. Lip seal:...
Cooling system — replacement of components
CAUTION! Risk of burns from hot steam and hot coolant. When the engine is warm, the cooling system is under excess pressure. To relieve excess pressure, place...
CAUTION! Risk of burns from hot steam and hot coolant. When the engine is warm, the cooling system is under excess pressure. To relieve excess pressure, place...
Compressor and intercooler
Compressor 1. Engine suspension eye. 2. Bolt: 27 Nm. 3. Compressor: with intercoolers: for assembly work, secure on the tilting device "VAS 6095"; to check for...
Compressor 1. Engine suspension eye. 2. Bolt: 27 Nm. 3. Compressor: with intercoolers: for assembly work, secure on the tilting device "VAS 6095"; to check for...
Fuel injection system — component layout
Overview of installation locations Right engine compartment 1. Ignition coils for cylinder bank 1: Coil 1 with power stage "N70". Coil 2 with power stage...
Overview of installation locations Right engine compartment 1. Ignition coils for cylinder bank 1: Coil 1 with power stage "N70". Coil 2 with power stage...
Exhaust System
Muffler 1. Bolt: 23 Nm. 2. Suspension mount: replace if damaged, check pre-tension. 3. Additional muffler: installed at the factory as one part with the rear...
Muffler 1. Bolt: 23 Nm. 2. Suspension mount: replace if damaged, check pre-tension. 3. Additional muffler: installed at the factory as one part with the rear...
Ignition system — removal and installation of components
Ignition system 1. Bolt: 9 Nm. 2. Hall sensor "G40". 3. Sealing ring: replace. 4. Knock sensors: knock sensor 1 "G61" (cylinder bank 1), knock sensor 2 "G66"...
Ignition system 1. Bolt: 9 Nm. 2. Hall sensor "G40". 3. Sealing ring: replace. 4. Knock sensors: knock sensor 1 "G61" (cylinder bank 1), knock sensor 2 "G66"...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar sections of other Audi car models:
Power unit: Petrol injection Audi 80 B4 (1991-1996)
General information: Maintenance (gasoline) Audi A6 C4 (1994-1997)
Power unit: Petrol engine 3.7L and 4.2L Audi A8 D2 (1994-2002)
Power unit: Fuel system (petrol) Audi Q5 Type 8R (2008-2017)
Power unit: Petrol injection Audi 80 B4 (1991-1996)
General information: Maintenance (gasoline) Audi A6 C4 (1994-1997)
Power unit: Petrol engine 3.7L and 4.2L Audi A8 D2 (1994-2002)
Power unit: Fuel system (petrol) Audi Q5 Type 8R (2008-2017)
Share information:
- General information
- Operating instructions
- Power unit
- Petrol engines 1.8 l
- Petrol engines 1.8/2.0 l
- Petrol engines 3.0 l
- Petrol engines 3.2 l
- Fuel system (petrol)
- Diesel engines 2.0 l (CA*)
- Diesel engines 2.0 l (CJCB)
- Diesel engines 2.7/3.0 l
- Diesel engines 3.0 l
- Fuel system (diesel)
- Transmission
- Manual gearbox 0B1
- Manual gearbox 0B2
- Manual gearbox 0B3
- Manual gearbox 0B4
- Automatic transmission 0B5
- Automatic transmission 0B6
- Automatic transmission 0AW
- All-wheel drive system
- Chassis
- Front suspension
- Rear suspension
- Brake system
- Steering system
- Body
- Exterior
- Interior
- Seats
- Doors, locks and windows
- Security system
- Heating and air conditioning
- Electrical equipment
- Audio system
- Power devices
- Equipment and devices
- Lighting and lamps
- Electrical circuits
- General information
- Introduction to manual
- Troubleshooting
- Operating instructions
- Maintenance
- Power unit
- Petrol engines 2.0 (ALT)
- Petrol engines 2.0 (TFSI)
- Petrol engines 1.8 (MPI)
- Diesel engines
- Cooling system
- Air conditioner
- Fuel and exhaust system
- Ignition system
- Starting and charging
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Front suspension
- Rear suspension
- Steering
- Body
- Exterior
- Interior
- Electrical equipment
- Equipment and devices
- Lighting and signaling
- Windscreen wipers and washers
- Electrical diagrams
- Electrical diagrams (since 2007)
- General information
- Vehicle Description
- User manual
- Maintenance
- Power unit
- Gasoline engine
- Diesel engine
- Lubrication system
- Cooling system
- Supply system
- Injection system
- Exhaust system
- Ignition and control
- Transmission
- Gear box
- Clutch and drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Heating and ventilation
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Power devices
- Lighting and appliances
- Electrical circuits
- General information
- Introduction to the guide
- Car care
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Injection and control system
- Ignition system
- Power and exhaust system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis
- Suspension and wheels
- Steering
- Brake system
- Body
- Interior
- Exterior
- Electrical equipment
- Equipment and devices
- Lighting and signaling
- Power devices
- Electrical circuits
- General information
- Introduction to the guide
- Car care
- Maintenance (gasoline)
- Maintenance (diesel)
- Power unit
- Gasoline engines
- Diesel engines
- Engine overhaul
- Cooling system
- Fuel injection (gasoline)
- Fuel system (diesel)
- Exhaust system
- Ignition system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior
- Interior
- Doors, locks and windows
- Heating and ventilation
- Electrical equipment
- Power devices
- Equipment and devices
- Electrical circuits
- General information
- Vehicle description
- Maintenance
- Power unit
- Engine repair
- Turbocharging
- Exhaust system
- Cooling system
- Ignition system
- Fuel system
- Motronic injection system
- MPI and MPFI injection system
- Transmission
- Clutch
- Gearbox and shafts
- Chassis
- Steering
- Car suspension
- Brake system
- Wheels and tires
- Body
- Heating and ventilation
- Body parts
- Electrical equipment
- Fuses and relays
- Power devices
- Lighting and lamps
- Tools and devices
- Electrical circuits