1. Jellied (she is the control) the plug is located on the left side of the gearbox housing, under the pilot's speedometer, in some models it can be hidden behind a heat shield (pic. 23.1). The cork may be "under the hexagon" 17 mm or "for Torx head".
2. Apply the handbrake, raise the vehicle and install safety stands. For accurate measurements, the vehicle must be installed horizontally.
3. Remove the plug.
4. The oil level should be 7 mm below the lower edge of the filler hole. Measure the level using a curved welding electrode or a piece of wire.
5. If necessary, drink the prescribed type of oil, bringing the level to the prescribed level. If the oil requires frequent topping up, make sure that there are no leaks, and eliminate those identified.
6. Replace the plug and tighten to the specified torque. Then lower the car.
Visitor comments