Gasoline engine 2.8L car Audi A8 D2

General information about the 2.8L petrol engine
The cars are equipped with six-cylinder V-shaped engines with liquid cooling. The engine is located longitudinally in the engine compartment. The engine...

Removal and installation the engine
Recommendations for engine removal Please read this section carefully before you begin. If the engine is removed for repair, it is necessary to select a place...

Poly V-belt
The poly V-belt drives the generator, power steering pump, radiator fan, air conditioning compressor and water pump, depending on the engine modification....

Vibration damper
Removal and installation Remove the poly V-belt. Unscrew the bolts and remove the vibration damper. When removing the vibration damper, it is not necessary to...

Replacing the timing belt
Warning: Before removing, mark the direction of rotation of the timing belt with chalk, marker or paint. If a used timing belt is installed with the opposite...

Dual mass flywheel
Remove the gearbox. By turning the engine crankshaft in the direction of its working rotation using the crankshaft pulley mounting bolt, set the piston of the...

Friction lining
Mark the position of the friction lining relative to the engine. Remove the bolts and friction lining. Fig. 3.1–66. Location of washer (2) and support washer...

Engine speed sensor
The engine speed sensor bracket can be moved by means of elongated holes. The bracket position is adjusted and cannot be changed. If the bracket mounting bolts...

Crankshaft
Check the crankshaft journals for roughness. Any noticeable roughness indicates the need for regrinding or replacement of the crankshaft. If the crankshaft has...

Pistons and connecting rods
Remove the cylinder head and oil pan. Turn the crankshaft and set the pistons of the first cylinder to the bottom dead center (BDC) position. If a ridge has...

Intake manifold
Fig. 3.1–41. Location of engine casing mounting screws Loosen the screws and remove the engine casing (see Fig. 3.1–41). Fig. 3.1–42. Location of the clamps...

Left cylinder head cover
Warning: Any clamps or clips that are damaged or cut when removing the cylinder head cover must be replaced with new ones when installing the cylinder head...

Right cylinder head cover
Warning: Any clamps or clips that are damaged or cut when removing the cylinder head cover must be replaced with new ones when installing the cylinder head...

Cylinder head
Remove the cylinder head on a cold engine. A burnt or defective cylinder head gasket is determined by the following signs: engine power reduction; coolant...

Camshaft
Removal Remove the timing belt from the camshaft pulleys. Remove the cylinder head cover. Remove the two bolts and the sensor housing from the rear of the left...

Checking hydraulic valve lifters
Correct valve clearances have a major impact on engine performance. If the valve clearances are too large, the engine will become noisy and less efficient...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: