Removal and installation of the engine Recommendations for removing the engine Read the entire section before removing the engine. If the engine is removed for repair, it is necessary first of all...
The front cross member of the engine compartment Withdrawal Before disconnecting the battery, find out if you have a radio activation code. Turn off the ignition and disconnect the wire «masses» from the...
V-ribbed belt The V-ribbed belt drives the generator, power steering pump, radiator fan, air conditioning compressor and water pump, depending on the engine modification....
Toothed belt Withdrawal Turn the crankshaft in the direction of working rotation by the pulley mounting bolt until the piston of the fifth cylinder is set to the TDC of the...
Crankshaft Check the crankshaft journals for roughness. Any noticeable roughness indicates the need for regrinding or replacement of the crankshaft. If the crankshaft has...
Left cylinder head cover Withdrawal Open the cap of the expansion tank. Remove the front cross member. Install a coolant drip tray under the engine. Pic. 3.4–17. Location of threaded...
Right cylinder head cover Withdrawal Remove the front cross member. Pic. 3.4–19. Removing the engine cover Pull the sides up to remove the engine cover (see fig. 3.4–19). Loosen the...
Removing the left cylinder head Pic. 3.4–52. Cylinder head: 1 - front middle pipe of the cooling system; 2 - bolt, 10 Nm; 3 - sealing ring; 4 – a head of the block of cylinders; 5 - guide...
Removing the right cylinder head Pic. 3.4–52. Cylinder head: 1 - front middle pipe of the cooling system; 2 - bolt, 10 Nm; 3 - sealing ring; 4 – a head of the block of cylinders; 5 - guide...
Camshaft Pic. 3.4–62. Valve mechanism: 1 - valve; 2 – a head of the block of cylinders; 3 - pressure limiting valve 2.7 bar, 25 Nm; 4 - oil deflector cap; 5 - valve...