Table of contents: Removal ↓ Installation ↓
Removal
1. Sensors (arrows in the accompanying illustration) located in the bumper.
Warning: Illustration shows front bumper.
2. Outer front sensors: Remove the headlight, refer to Section Removal and installation headlights.
3. Inner front sensors: Remove the front bumper, refer to Section Removal and installation the front bumper.
4. Rear sensors: Remove the rear bumper, refer to Section Removal and installation the rear bumper.
5. Disconnect the sensor connector (1).
6. Press the 2 locking plates (arrows) to the side and push the sensor out of the bumper.
Installation
1. Installation is performed in the reverse order of removal.
[This article was copied from an online resource: AUDImanual]