Removal
1. Open the hole (1) in the trunk trim.
2. Unscrew the screw (3) and fold the rear light outward, removing the ball pin from the wing.
3. Disconnect the connector on the lamp panel.
Installation
1. Connect the connector to the lamp panel.
2. Install the rear light on the body so that the pins are pressed into the bushings (7). At the same time, ensure that the seal is correctly positioned.
- 1 - Side light
- 2 — Brake light/side light
- 3 — Rear direction indicator
- 4 — Reversing light
- 5 - Fog lamp
- 6 — Connecting plug
- 7 — Bushings
3. Tighten the screw (3) to the torque 6Nm.
4. If necessary, unscrew the nut (2) and adjust the rear light to ensure a uniform gap with respect to the adjacent parts of the body. Tighten the nut to the torque 12Nm.
Replacing incandescent lamps
1. Squeeze the 2 retaining tabs (arrows) and remove the lamp panel from the rear light.
- 1 - Side light
- 2 — Brake light/side light
- 3 — Rear direction indicator
- 4 — Reversing light
- 5 - Fog lamp
- 6 — Connecting plug
- 7 — Bushings
2. Press bulbs (1) to (5) into the sockets, twist and remove. Replace the bulbs with new ones.
Warning: If the reversing light bulb still does not light after replacement, you need to check the switch. The switch is located on the gearbox above the drive shaft flange.
Station wagon
Removal
1. Open the tailgate and remove the plug from the trim.
2. Remove the bolt (1). Fold the rear light outward, removing the ball pin from the wing.
3. Disconnect the lamp panel connector.
Installation
1. Connect the lamp panel connector.
2. Install the rear light on the body so that the fingers are pressed into the seals (6). At the same time, ensure that the seal is correctly positioned.
- 1 - Fog lamp
- 2 — Rear direction indicator
- 3 - Reversing light
- 4 — Brake light/side light
- 5 — Connecting plug
- 6 - Bushings for fingers
3. Tighten the screw (1) to the torque 6Nm.
4. If necessary, unscrew the nut (2) and adjust the rear light so as to obtain a uniform gap in relation to the adjacent body elements. Tighten the nut to the torque 12 Nm.
Replacing incandescent lamps
1. Press the four locking bars outward (arrows in the accompanying illustration) and remove the lamp panel from the rear light.
2. Press the bulbs (1) to (4) into the sockets, twist and remove. Replace the bulbs with new ones.
- 1 - Fog lamp
- 2 — Rear direction indicator
- 3 - Reversing light
- 4 — Brake light/side light
- 5 — Connecting plug
- 6 - Bushings for fingers
Warning: If the reversing light bulb still does not light after replacement, you need to check the switch. The switch is located on the gearbox above the drive shaft flange.