Withdrawal
1. Remove the disc/hub as described in paragraph 9.
2. Turn away bolts of fastening of a brake board. remove it along with the axle (pic. 10.2, a, 6).
3. A worn or damaged axle must be replaced.
Installation
4. Make sure the mating surfaces are clean. Remove interfering burrs with a needle file or sandpaper.
5. Mount the brake shield with axle and secure with bolts Tighten the bolts to the prescribed torque in a diagonal sequence (pic. 10.5).
6. Install the hub/disk as described in paragraph 9.
Visitor comments