If desired, the driver and front passenger can adjust the air conditioning.
The left display of the air conditioner shows the set temperature on the driver's side, and the right display shows the temperature on the front passenger side.
The temperature is set by pressing the "+" and "–" buttons near the corresponding display.
The air conditioner functions are turned on and off by pressing the buttons; the LED in the button that is on lights up.
Recommended standard procedure for setting air conditioner modes for any season
- Turn on the ignition.
- Set the temperature to 22°C (71°F).
- Click on the button AUTO.
In this mode of operation of the air conditioner, the most comfortable climate in the car is achieved. Temperature, flow rate and air distribution are regulated automatically.
Fig. 1–53. Air conditioner control panel
Buttons "–" and "+" for setting the temperature. The temperature in the car's interior can be set between 18 and 29°C (64–84°F). In the end positions LO and Hl the temperature is not adjustable.
Switching temperature from°C to°F.
Click the button
and hold it in this position. Then press the temperature setting button on the left side.
Defrosting glass. The windshield and side windows are quickly defrosted. The temperature is regulated automatically. The maximum air flow is supplied from ventilation nozzles 1 and 2.
Air recirculation. Pressing the key switches on the air recirculation mode. To switch off the air recirculation, press the recessed button again.
Operating the air conditioner in recirculation mode prevents unpleasant odors from entering the passenger compartment, for example when driving in a tunnel or traffic jam.
If you need to quickly lower the air temperature in the cabin, you can set the recirculation mode, in which air is sucked in from the cabin and cooled.
The air recirculation mode can only be switched on for a short time, since in this mode fresh air does not enter the vehicle interior.
ECON–economy mode. To save fuel, the air conditioning compressor can be switched off. When the air conditioning compressor is switched off, the comfort mode in the car is disrupted.
If the temperature in the car is too high or the windows start to fog up, you need to turn on the air conditioning compressor by pressing the button again ECON, and then on the buttonAUTO.
Buttons "–" and "+" for fan speed.
Used to decrease or increase the automatically selected fan speed. The fan speed is displayed in segments on the display located between the buttons.
REST – residual heat. This function can be activated within 30 minutes after the ignition is turned off. In this case, the interior is heated by the heat of the coolant.
The maximum heating time is 12 minutes.
OFF – turns off the air conditioner. When you press the button, the air conditioner turns off, but the flow of outside air is blocked.
To turn the air conditioner back on, press the button AUTO or OFF.
Air distribution buttons. By pressing buttons
, 
and 
you can change the direction of air flow in the car. The buttons can be pressed either individually or in any combination.
the amount of air flow does not increase.
Air supply from the instrument panel ventilation grilles. All air flow is supplied from the instrument panel ventilation grilles 3 and 4, as well as from the rear ventilation grilles of the center console.
Supplying air to the legs. The entire air flow is supplied to the ventilation nozzles 5 and under the front seats.
(This article was copied from an online resource Audimanual.ru)