Warning: In cold weather, before turning on the wipers for the first time, check to see if the brushes are frozen.
Switching off the windshield wipers. Steering column switch in fixed position 0.
Manual control of the movement of the brushes. Move the stalk switch down to the fixed position.
Intermittent brush movement. Steering column switch in fixed position 1, while the interval of operation of the brushes is 6 s.
The brush response intervals can be continuously set from 1.5 to 22 s.
To do this, set the switch to a fixed position 1 and after a single operation of the brushes, turn it off. Then, after the desired time interval, turn the switch back on. After the ignition is switched off, the brush interval is again 6 s.
Slow brush movement. Steering column switch in fixed position 2.
Fast brush movement. Steering column switch in fixed position 3.
Automatic cleaning and washing. Move the steering column switch to the steering wheel - wipers and washer work.
Release stalk switch – the windshield washer stops, the wipers continue to operate for approximately 4 seconds.
headlight washer. When the high beam or low beam is on, each time the windshield washer is turned on, the surfaces of the headlamp lenses are washed.
Visitor comments