Windshield wipers and washers operate only when the ignition is on.
In frost, before turning on the wiper for the first time, check if the brushes are frozen!
The windshield washer jets are heated when the ignition is on.
Windshield
- 1 start-stop mode
- 0 shutdown
- 2 interval mode
Regulator (A) You can change the duration of the wiper intervals in steps.
The duration of the intervals when operating in the modes of individual steps also depends on the speed of the vehicle.
- 3 slow mode
- 4 fast track
- 5 joint operation of windshield wipers and windshield washers in automatic mode
When pulling the lever towards the steering wheel, the windshield wipers and washers operate.
When the light is on and the lever is held in this position for more than 1 second, the headlight cleaner* is also activated.
Release the lever - the windshield washers turn off, the brushes work for about 4 seconds.
Rear glass
1 interval mode
Press the lever forward - the brush works every 6 seconds.
The rear window wiper turns off when the lever is returned to its original position.
2 joint operation of the wiper and washer in automatic mode
Press the lever forward - the wiper and washer are activated.
Release the lever - the windshield washer is switched off, the brush works for about 4 seconds.
Headlight cleaner*
When the lights are on and each time the windshield washer is used, the headlight lenses are also washed.
With each operation of the system, the headlight washer jets are pushed out under the pressure of water.
Regularly, e.g. when refueling, remove stubborn dirt from the headlight lenses (traces of insects).
To keep the system working in winter conditions, clean the nests of the washer jets from snow, and also remove ice from there, using an aerosol defroster for this.
Visitor comments