Execution order
1. Loosen the flywheel mounting bolts evenly by 1–2 turns.
2. Unscrew the bolts and remove the flywheel from the crankshaft. When removing the drive disk, it is necessary to mark the location of the gaskets.
3. Install the flywheel or drive disk in the reverse order. Apply sealant to the bolt threads before installation. Tighten the bolts to a torque of 100 N·m (10.0 kgf·m). If the drive disk has been replaced, check and, if necessary, adjust its position. The distance from the rear wall of the cylinder block to the mounting surface of the transformer on the drive disk should be from 30.5 to 32.1 mm. You can adjust the position of the drive disk by installing a gasket between it and the crankshaft.
Read the original source on the website AUDIMANUAL