Removal
1. On manual transmission models, remove the transmission and clutch.
2. On models with automatic transmission, remove the transmission.
3. Unscrew the flywheel bolts, having first locked it.
4. Remove the flywheel.
Examination
1. Check the flywheel for wear and damage. If any is found, contact a specialist.
2. If you are installing a new flywheel, it only has a mark for setting piston N1 to TDC. You will need to put a mark on it to set the ignition timing angle (a = 14.6 mm).
3. Inspect the crankshaft needle bearing.
Installation
Installation is carried out in the reverse order of removal.
1. Apply sealant to the flywheel bolts.
2. Install the drive disk (a = 27 mm±1 mm).
3. Tighten the flywheel bolts.